Intellibox with Rocrail

Post Reply
JakevanKaye

Intellibox with Rocrail

Post by JakevanKaye » 07.01.2011, 22:43

After a few hours trying the settings and loading the Rocrail server and Rocview i finally got the trains running and controlled by rocrail. It looks very good. (3rail Roco/Marklin, Intellibox IR, Com port4, Baudrate 19200, Bits8, P50x)
BUT after turning off the laptop and Intellibox and turn them back on there was no Loco and no parameter saved in Rocrail! I did save the plan though but could not re-open nor re-open the last saved session. Does any one have tips how to save and safely re-open Rocrail with every Loc and turnout that was assigned and programmed and saved?

I would be very grateful. Thnx


Jake

Post Reply

Return to “P50 and P50x”