Digitrax PR3 USB

Moderator: Moderators

Digitrax PR3 USB

Postby speedy » 25.09.2012, 13:52

hi all,
I got a new Digitrax PR3 and hooked it up to my Mac (OSX 10.7.4) via USB. Trying to configure the interface in "Zentrale", I can choose loconet/interface /PR3 but with no USB option. It offers a com port type of setting instead. Rocview consequently says "no initited loconet interface. Any idea what I have to do for a usb connection.
You do not have the required permissions to view the files attached to this post.
Gruss
Bernhard "Speedy"
speedy
 

Postby rjversluis » 25.09.2012, 14:19

Your new interface will map as serial device.

Check this command:

http://wiki.rocrail.net/doku.php?id=mac ... ial_driver
Best Regards, Rob.
:!: PS: Do not forget to attach the usual files.
:!: PS: Nicht vergessen die übliche Dateien an zu hängen.
[ macOS - Linux] - [ N: CBus - CAN-GCA ] - [ 0: RocNetNode - GCA-Pi ]
rjversluis
Site Admin
 

Postby speedy » 27.09.2012, 00:20

Hi Rob, thanks for the answer. That's what I got
crw-rw-rw- 1 root wheel 18, 6 26 Sep 21:16 /dev/tty.SGH-ZV10-SerialPort
crw-rw-rw- 1 root wheel 18, 10 27 Sep 00:56 /dev/tty.usbmodemfd1211

Tried out both and the latter one kind of works, but still lots of error messsages like

Could not get slot for loco addr=1. (no response...)

Programming a decoder ends with : "no confirmation.... ", although it obviously took the CV value correctly. Reading out a decoder fails completely though.

regards
Gruss
Bernhard "Speedy"
speedy
 

Postby rjversluis » 27.09.2012, 06:01

Hi Bernhard,

just search in the Forum with PR3 for helpfull hints:
http://forum.rocrail.net/search.php
Best Regards, Rob.
:!: PS: Do not forget to attach the usual files.
:!: PS: Nicht vergessen die übliche Dateien an zu hängen.
[ macOS - Linux] - [ N: CBus - CAN-GCA ] - [ 0: RocNetNode - GCA-Pi ]
rjversluis
Site Admin
 


Return to Loconet