config Turnout digital decoder 74460 in Rocview

agre30
Posts: 874
Joined: 24.12.2011, 20:41
Location: Netherland
Contact:

Post by agre30 » 08.01.2013, 18:59

Magnus,
The file Rocrail.ini is missing in the Rocrail directory, so I cannot see how your command station is configured, but because you can run trains I assume you did that right.

Lets say your switch sw1 has adress 11.
On the Interface tab you should choose protocol: Motorola, Adress 4, Port 3
If sw2 has adress 12, you choose Adress 4, Port 4 (and of course protocol: Motorola)

I hope this works.

Albert.

mryde

Switch 74460

Post by mryde » 08.01.2013, 19:55

Eureka!!

That was it. I did change the power connectors and indeed it worked. I am embarrassed but also happy. How odd that he locos work as the shall buy not the turnouts! Not very good.

Anyway, Thanks!

Now I can dig into Rocrail deeper. Hopefully I will avid these kind of weird problems in the future.

Again, thanks a million!!!

Magnus

:lol:

Post Reply

Return to “ECoS - Marklin CS1”