Rocrail - Innovative Model Railroad Control System
Copyright © 2002-2018 Robert Jan Versluis, Rocrail.net. All rights reserved.
Rocrail-Wiki • Support-Key • Revisions • Download • New EN-posts • Active EN-topics • CHATProblem in rocview.
Moderator: Moderators
3 posts
• Page 1 of 1
Problem in rocview.
by Buddace » 27.02.2010, 10:52
Some times with edit mode disable double click move modules..I think it is bug.
www.dccworld.com First and Only Italian DCC Website.
TMWDCC/TBX , zDCC, Lokmaus 2, Arnold DCC, Intellibox, Hornby Select, A lot of Loconet DIY (Loconet SwitcBoard, Loconet P50, etc..)
TMWDCC/TBX , zDCC, Lokmaus 2, Arnold DCC, Intellibox, Hornby Select, A lot of Loconet DIY (Loconet SwitcBoard, Loconet P50, etc..)
by rjversluis » 27.02.2010, 11:54
Best Regards, Rob.
PS: Do not forget to attach the usual files.
PS: Nicht vergessen die übliche Dateien an zu hängen.
[ macOS - Linux] - [ N: CBus - CAN-GCA ] - [ 0: RocNetNode - GCA-Pi ]
PS: Do not forget to attach the usual files. PS: Nicht vergessen die übliche Dateien an zu hängen.[ macOS - Linux] - [ N: CBus - CAN-GCA ] - [ 0: RocNetNode - GCA-Pi ]
- rjversluis
- Site Admin
by Buddace » 21.06.2010, 08:34
Again same problem some time modules ... walk around monitor..I don't know why and can't reproduce. First idea is problem caused from hide loco panel.
www.dccworld.com First and Only Italian DCC Website.
TMWDCC/TBX , zDCC, Lokmaus 2, Arnold DCC, Intellibox, Hornby Select, A lot of Loconet DIY (Loconet SwitcBoard, Loconet P50, etc..)
TMWDCC/TBX , zDCC, Lokmaus 2, Arnold DCC, Intellibox, Hornby Select, A lot of Loconet DIY (Loconet SwitcBoard, Loconet P50, etc..)
3 posts
• Page 1 of 1