conecting sprog with mac

http://www.sprog-dcc.co.uk/

Postby rjversluis » 18.08.2009, 19:29

Hi James,

I added the rocrail.ini and the plan.xml which only contains some loco's.
I tested the SPROG with the "Köf" loco.
You do not have the required permissions to view the files attached to this post.
Best Regards, Rob.
:!: PS: Do not forget to attach the usual files.
:!: PS: Nicht vergessen die übliche Dateien an zu hängen.
[ macOS - Linux] - [ N: CBus - CAN-GCA ] - [ 0: RocNetNode - GCA-Pi ]
rjversluis
Site Admin
 

Postby ViktorHotel » 18.08.2009, 21:29

Hi James, hi Rob,

just an idea, maybe offtopic:
SprogII sends ResetPackages at PowerOn (http://forum.rocrail.net/viewtopic.php?t=988)
Andrew is working on an update. He said:
"I don't think the reset packets are necessary when operating as a command station. The code is shared with the programming algorithm, where the reset packets always need to be sent."

a short test might help:
1. power off
2. remove the loco from rails
3. power on
4. wait >500ms ?
5. put loco on rails
6. testdrive

Regards,
Volker
ViktorHotel
 

Postby rjversluis » 02.09.2009, 14:03

Hi James,

the sprog implementation in Rocrail only supports the default 128 speed steps:

http://forum.rocrail.net/viewtopic.php?t=1091

28 will not work.
Best Regards, Rob.
:!: PS: Do not forget to attach the usual files.
:!: PS: Nicht vergessen die übliche Dateien an zu hängen.
[ macOS - Linux] - [ N: CBus - CAN-GCA ] - [ 0: RocNetNode - GCA-Pi ]
rjversluis
Site Admin
 

Postby jimmielx » 02.09.2009, 14:30

Hi Rob

That's it! The locos were set to 28 speed steps and having changed this to 128 everything seems to be working perfectly now. Thank you so much to all for your help with this.

James
jimmielx
 

Previous

Return to sprog