instability with SPROG commands

http://www.sprog-dcc.co.uk/

instability with SPROG commands

Postby xtof » 21.11.2010, 14:15

Sometime, when I try to run a locomotive at full speed, I receive this type of message in the Trace of the controller:

slot=0 addr=33 V=128 steps=128 dir=1 long=0SPROG read: [P> P> P> P> P> P> P> P> P> P> P> P> P> P> P> P> P> 3 ]
SPROG read: [ ]SPROG read: [P> 3 ]
SPROG read: [ ]SPROG read: [P> 3 ]
SPROG read: [ P>3 ]SPROG read: [ P> 3 ]
SPROG read: [ ]SPROG read: [P> 3> P> 3 ]
SPROG read: [ ]SPROG read: [P> 3> P>3 ]
SPROG read: [ P> 3 ]SPROG read: [ ]
SPROG read: [P> 3> P> 3 ]SPROG read: [ ]
Loco command for address 33Loco slot=0

Any idea about this problem?
You do not have the required permissions to view the files attached to this post.
XTof.VL
Saroulmapoul
Raversijde 1913
xtof
 

Postby rjversluis » 21.11.2010, 19:30

Hi,

is the trace the problem? Or is something else happening too?
Best Regards, Rob.
:!: PS: Do not forget to attach the usual files.
:!: PS: Nicht vergessen die übliche Dateien an zu hängen.
[ macOS - Linux] - [ N: CBus - CAN-GCA ] - [ 0: RocNetNode - GCA-Pi ]
rjversluis
Site Admin
 

Postby xtof » 21.11.2010, 20:36

When that happens, I heard some beeps and the loc doesn't respond to the command. The whole set became unstable (no more control of locs possible), and I have to restart or RocRail, or even the computer sometime.
XTof.VL
Saroulmapoul
Raversijde 1913
xtof
 

Postby rjversluis » 21.11.2010, 20:55

Maybe you should update your sprog II firmware to the latest revision.
Best Regards, Rob.
:!: PS: Do not forget to attach the usual files.
:!: PS: Nicht vergessen die übliche Dateien an zu hängen.
[ macOS - Linux] - [ N: CBus - CAN-GCA ] - [ 0: RocNetNode - GCA-Pi ]
rjversluis
Site Admin
 

Postby xtof » 21.11.2010, 22:17

It's no more available:

http://www.bbmgroup.com/sprog/download.html

Due to recurring problems encountered by people attempting to upgrade their SPROG II firmware themselves, the user updates were temporarily suspended.
XTof.VL
Saroulmapoul
Raversijde 1913
xtof
 

Postby RainerK » 21.11.2010, 22:29

Hi,

and the support wrote at same site:
Contact us directly to arrange an upgrade.

Best Regards
RainerK
Best Regards, es grüßt RainerK

DCC++ with Arduino Uno / Motor shield and LocoNet GCA85, 50, 93 and 136. Special interests: DIY electronic assemblies. http://www.rainermoba.blogspot.com
Planning replace the coincidence by the mistake
RainerK
 

Postby xtof » 21.11.2010, 22:33

Asked.

Thanks!
XTof.VL
Saroulmapoul
Raversijde 1913
xtof
 


Return to sprog