[solved] German translation...

[solved] German translation...

Postby rjversluis » 15.07.2014, 07:58

Previous translation:
Code: Select all
    <en txt="Restart to change language."/>
    <de txt="Zum Ändern der Sprache neu starten."/>

New translation:
Code: Select all
    <en txt="Restart to change language."/>
    <de txt="german"/>

This new translation is rejected.
Please correct it at LP.

Normally I do not check the new translations because 90% of the languages are unknown to me...
Best Regards, Rob.
:!: PS: Do not forget to attach the usual files.
:!: PS: Nicht vergessen die übliche Dateien an zu hängen.
[ macOS - Linux] - [ N: CBus - CAN-GCA ] - [ 0: RocNetNode - GCA-Pi ]
Site Admin

Re: German translation...

Postby woodyboy » 15.07.2014, 08:10

I would like to propose: Restart translation :wink:


Equipment: Roco WLANMaus, MS2, Gleisbox 2x(separated switch & rollingstock). Ubuntu 16. Edits booster. Arduino: S88 CANbus interface & Ethernet-CANbus gateway

Re: German translation...

Postby RainerK » 15.07.2014, 08:15

Hi Rob,

I think "HK" did not really know what he was doing
and so i changed it back to the previous only sense making translation.

Best Regards
Best Regards, es grüßt RainerK

DCC++ with Arduino Uno / Motor shield and LocoNet GCA85, 50, 93 and 136. Special interests: DIY electronic assemblies. http://www.rainermoba.blogspot.com
Planning replace the coincidence by the mistake

Return to Translations