Conecting CS3plus to RocRail / PC

Märklin Central Station 2

Conecting CS3plus to RocRail / PC

Postby VT601 » 24.02.2017, 09:08

I have been following the RocRail forum for some time now, and I can run some trains using the virtual command station.
I haven't connected my RocRail setup yet to any other command station yet.

Lately I have ordered the Märklin CS3plus command station, withs have have been able to connect to my laptop using a wired connection via my router and al wireless connection with my PC.
I can see and operate my CS3plus through VNC viewer.
With restrictions I also have been able to use a virtual Command Station as delivered with cs2.exe.

Now I have been trying to connect my Rocrail setup using the msc2 command station in my RocRail Properties as described in the wiki.
Still I do not get a connection with the CS3plus established.

Has anyone allready some experiences with this combination?
You may respond in English, German or Dutch whatever suits you best.

John
Building a Marklin-based model railroad using (still) 6021 (central unit) and MS2.
Era: IV, Germany
Member of M-Track Nederland (m-track.org)
Member of 3railforum.nl
Reads and write: EN, DE and NL
VT601
 

Re: Conecting CS3plus to RocRail / PC

Postby rjversluis » 24.02.2017, 09:40

Hi John,

there is a German thread about the CS3:
viewtopic.php?f=47&t=12572
Best Regards, Rob.
:!: PS: Do not forget to attach the usual files.
:!: PS: Nicht vergessen die übliche Dateien an zu hängen.
[ macOS - Linux] - [ N: CBus - CAN-GCA ] - [ 0: RocNetNode - GCA-Pi ]
rjversluis
Site Admin
 

Re: Conecting CS3plus to RocRail / PC

Postby VT601 » 24.02.2017, 11:17

Thnx,
I have looked into this section all ready, but found no solutions yet.

John
Building a Marklin-based model railroad using (still) 6021 (central unit) and MS2.
Era: IV, Germany
Member of M-Track Nederland (m-track.org)
Member of 3railforum.nl
Reads and write: EN, DE and NL
VT601
 


Return to CS2