CV Programming through GCA101 - Intellibox Basic

Uhlenbrock new generation CS-Line

CV Programming through GCA101 - Intellibox Basic

Postby dguisado » 24.04.2013, 23:10

Hello,

I have seen similar posts, but all of them connecting directly Intellibox to Rocrail I guess. In my case, I have a GCA101 and connected to Rocrail through Ethernet.

CV programming doesn't work at all. I tried pushing the PT button in Rocrail, without, changing manually Intellibox to programming track,.... but no combination was successful. Always says when reading:

"LONG_ACK: The Slot Write command was rejected
LNCV response"

But when I read manually a CV directly from Intellibox, it is received by Rocrail, but in a wrong CV number, and says:

"IB-Com PT command
Read Programming Track: Read Unknown mode; Could be IB-Com Setting CV1 to 98 (0x62)
Status = Success
"

Do I have to setup Intellibox in a special way? May be I have to go to programming track in Intellibox and enter in some menu?
Any suggestion??

Thanks a lot,
Dani.
dguisado
 

Re: CV Programming through GCA101 - Intellibox Basic

Postby dguisado » 17.06.2014, 07:45

Hello,

After one year, I still cannot program or read CV from Rocrail using Intellibox Basic. I tried connecting rocrail through a GCA101 (LNUDP), or directly to the Intellibox USB (loconet ULNI).
Nobody is using this command station?

Thanks,
Dani
dguisado
 

Re: CV Programming through GCA101 - Intellibox Basic

Postby rjversluis » 17.06.2014, 07:49

Hi,

just attach your rocrail.*.trc file in which your programming tries are listed.

http://wiki.rocrail.net/doku.php?id=pt-en#pt
Best Regards, Rob.
:!: PS: Do not forget to attach the usual files.
:!: PS: Nicht vergessen die übliche Dateien an zu hängen.
[ macOS - Linux] - [ N: CBus - CAN-GCA ] - [ 0: RocNetNode - GCA-Pi ]
rjversluis
Site Admin
 


Return to IB-Basic IB-Com IB2