Massive Delays until commands are executed

iPad based Rocrail client

Massive Delays until commands are executed

Postby Videoman » 17.09.2014, 08:28

I recently used Padroc on my layout. It connected fine works ok for most of the time.
From time to time, it took massive amount of time, until a command I send was actually send to the control station. I mean 10 to 15s second, the following commands were fine afterwards. This kind of delays resulted in a few collision, because the Power OFF command was not send in time. I didn't use the automatic mode, just to control the locomotives.

Has anyone seen that problem ? I don't need raction in ms, but after latest a half second it should happen something.
Videoman
 

Re: Massive Delays until commands are executed

Postby rjversluis » 17.09.2014, 08:40

Maybe your WiFi connection is of bad quality or too far away and padRoc must make several retries to reconnect.
Best Regards, Rob.
:!: PS: Do not forget to attach the usual files.
:!: PS: Nicht vergessen die übliche Dateien an zu hängen.
[ macOS - Linux] - [ N: CBus - CAN-GCA ] - [ 0: RocNetNode - GCA-Pi ]
rjversluis
Site Admin
 

Re: Massive Delays until commands are executed

Postby Videoman » 18.09.2014, 07:18

I will try it with better connection. Maybe i see a pattern.
Videoman
 


Return to padRoc