new to rocrail unsure to this problem

new to rocrail unsure to this problem

Postby 4527pink » 31.03.2018, 09:57

Okay.
I set up rocrail and is communicating with my NCE Power Pro all is good , but on the bottom right hand side there is only one green box the other are red
the power is set on , I assumed there should have be all green ,
although My Locos still run fine,
The other is when I add a new loco to the roster, every time as I set one up I have to exit rocrail and restart rocrail to get the command station to recognise the new loco that I just added. I think I have missed something on the way
Andrew.
4527pink
 

Re: new to rocrail unsure to this problem

Postby rjversluis » 31.03.2018, 10:10

Hi Andrew,

the LEDs are not important and not supported by all command stations.

If you added a new loco there is no need to restart Rocrail; It should run.
The NCE CS do not need a loco list for initialising.
Best Regards, Rob.
:!: PS: Do not forget to attach the usual files.
:!: PS: Nicht vergessen die übliche Dateien an zu hängen.
[ macOS - Linux] - [ N: CBus - CAN-GCA ] - [ 0: RocNetNode - GCA-Pi ]
rjversluis
Site Admin
 

Re: new to rocrail unsure to this problem

Postby 4527pink » 31.03.2018, 10:40

Thank you for your reply.
relive with the light bar,
With a new loco when I click on the menu bar to move the loco nothing happens ,
I shall try another and see how things go,
I get there
Andrew.
4527pink
 

Re: new to rocrail unsure to this problem

Postby 4527pink » 01.04.2018, 04:04

just to say all working as you said it will.
Andrew
4527pink
 


Return to Smalltalk