arduino:wio-en
Differences
This shows you the differences between two versions of the page.
| arduino:wio-en [2025/03/12 08:53] – created - external edit 127.0.0.1 | arduino:wio-en [2025/05/19 20:57] (current) – [StepMotor] babbel | ||
|---|---|---|---|
| Line 755: | Line 755: | ||
| | 2 | IN3 | ENABLE+ | | | 2 | IN3 | ENABLE+ | | ||
| | 15 | IN4 | - | | | 15 | IN4 | - | | ||
| - | | 25 | - | | Hall/Reed calibrate sensor | | + | | 25 | - | | Hall/Reed calibrate sensor |
| | EP1-1 | GND | CLK-, | | EP1-1 | GND | CLK-, | ||
| | - | VCC | 12V-45V DC | External power supply | | | - | VCC | 12V-45V DC | External power supply | | ||
| + | |||
| + | |||
| + | * The calibration sensor should be installed as close as possible to track 0 | ||
| + | |||
| ===Turntable Setup=== | ===Turntable Setup=== | ||
| | Turntable Interface | | Turntable Interface | ||
arduino/wio-en.txt · Last modified: 2025/05/19 20:57 by babbel · Currently locked by: phil45