Differences

This shows you the differences between two versions of the page.

--- arduino:wio-setup-en [2025/05/26 09:28] – [CVs] rjversluis
+++ arduino:wio-setup-en [2025/10/16 11:51] (current) – [Pulse] rjversluis
@@ Line 4: / Line 4: @@
 [[:wio:overview-en|{{ :wio:wiologo.png}}]]
 **[[:wio:overview-en|WIO Overview]]**
-  * **[[:arduino:wio-setup-en|WIO Setup]]** | [[:arduino:wioctrl-en|WIO Control]] | [[:arduino:amp-en|User Bitmaps]] | [[:arduino:wio-en|WIO Firmware]] | [[:wio:wio-ledscript-en|LEDScript]]
+  * **[[:arduino:wio-setup-en|WIO Setup]]** | [[:arduino:wioctrl-en|WIO Control]] | [[:arduino:amp-en|User Bitmaps]] | [[:arduino:wio-en|WIO Firmware]] | [[:wio:wio-ledscript-en|LEDScript]] | [[:wio:wio-ioscript-en|IOScript]]
@@ Line 105: / Line 105: @@
 Count of 100ms for setting the output pulse length.\\
 Also used for dual coil switch motors.\\
+====Block timer====
+The time between the last upper flank and reporting the sensor off.\\
+Default 2 seconds. (2000ms)\\
 ====Port====
@@ Line 354: / Line 358: @@
  \\
-=====OTA from Scratch=====
+====OTA from Scratch====
 To avoid bothering with the needed libraries for the WIO Sketch this {{:wio:rrota.zip|WPS-OTA-Sketch}} can be used for binary OTA:\\
 ( The Sketch can also be downloaded from https://gitlab.com/rocrail/rrota )
@@ Line 375: / Line 379: @@
  \\
+<html><a name="files"/></html>
+=====Files=====
+File management for WIO CAN.\\
+ \\
+<html><a name="iomapping"/></html>
 =====I/O Mapping=====
 {{:arduino:wio-iomapping-en.png?800}}\\
@@ Line 400: / Line 411: @@
  \\
+<html><a name="usercv"/></html>
 =====User CV=====
 ====Interface====
@@ Line 438: / Line 450: @@
 |  12  | Stepper_ISR_Accel | |  50 | | | | Start/end delay (number of steps for accelerate and decelerate) -> range |
 |  13  | Stepper_ISR_Accel_Step | |  15 | | | | Number of ticks before add/subtrackt accelerate and decelerate -> speed |
+|  14  | User_altitude |  |  104 | | | | https://whataltitude.com |