User Tools

Site Tools


can-gca2-en

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revisionPrevious revision
Next revision
Previous revision
can-gca2-en [2025/05/15 16:16] – [CAN-GC2 Universal 16 port I/O node for CANBUS] phgcan-gca2-en [2025/06/09 19:11] (current) – [The hardware] phg
Line 14: Line 14:
 the CAN-GC2 can be mixed with GCA50 units on the same cable, but of course need different computer interfaces.\\ the CAN-GC2 can be mixed with GCA50 units on the same cable, but of course need different computer interfaces.\\
 The also available CAN-GC3 will bring a complete solution for DCC Model Railroading in DIY. \\ The also available CAN-GC3 will bring a complete solution for DCC Model Railroading in DIY. \\
-The CAN-GC1e connects the computer with the CAN bus. All the well known MGV*/GCA* satellite boards are compatible with the CAN-GC2.  \\+The CAN-GC1e connects the computer with the CAN bus. All the well known MGV*/GCA* satellite boards are useable with the CAN-GC2.  \\
  
  
Line 44: Line 44:
 |  {{:cbus:can-gc2-green-bomfile.pdf|The partslist}}  | |  {{:cbus:can-gc2-green-bomfile.pdf|The partslist}}  |
 |  {{ :gca:can-gc2_stl.zip |  3D print sources for housing}}  | |  {{ :gca:can-gc2_stl.zip |  3D print sources for housing}}  |
 +^  N.B. Only complete ordered kits will be supported!  ^
 \\ \\
-N.B. Only complete ordered kits will be supported! ^+     Housing is only for DIY 3D printing ^ 
 +|  {{ :gca:can-gc2.zip |  Box and cover for CAN-GC2}}  |
 \\ \\
 === Previous version (blue pc-board) === === Previous version (blue pc-board) ===
Line 116: Line 118:
 Read switches and hall sensors can be used as feed-back sensors.\\ Read switches and hall sensors can be used as feed-back sensors.\\
 However, since the contact information inside the CAN-GC2 is arranged so that the unit is\\ However, since the contact information inside the CAN-GC2 is arranged so that the unit is\\
-low sensitive for distorsions, the minimum Pulse lenght to be accepted by CAN-GC2 is 20 miliSeconds (0.02 second).\\+low sensitive for distorsions, the minimum Pulse lenght to be accepted by CAN-GC2 is 50 miliSeconds (0.05 second).\\
 In addition to that, reed-contacts usually give more than 1 pulse when activated, known as 'contact dender'.\\ In addition to that, reed-contacts usually give more than 1 pulse when activated, known as 'contact dender'.\\
 For this way of sensoring, a special pulse-extender is available. See __**[[gca173-en|Hall sensor and reed switch unit]]**__\\ For this way of sensoring, a special pulse-extender is available. See __**[[gca173-en|Hall sensor and reed switch unit]]**__\\
can-gca2-en.1747318619.txt.gz · Last modified: 2025/05/15 16:16 by phg