Differences

This shows you the differences between two versions of the page.

--- loc-calibrate-en [2024/01/28 17:10] – created - external edit 127.0.0.1
+++ loc-calibrate-en [2025/10/27 11:07] (current) – rjversluis
@@ Line 2: / Line 2: @@
 [[:english#objects|{{  :objects.png}}]][[:english|{{  :rocrail-logo-35.png}}]]
 [[english|Content]] -> [[english#objects|Objects]] -> **Locomotives**
-  *  [[loc-index-en|Index]] | [[loc-gen-en|General]] | [[loc-int-en|Interface]] | [[:loc-speed-en|Speed]] | [[loc-details-en|Details]] | [[loc-fun-en|Functions]] | [[loc-consist-en|Multiple Units]] | [[loc-cv-en|CVs]] | [[loc-bbt-en|BBT]] | [[loc-bat-en|BAT]] | [[loc-sbt-en|SBT]] | **[[loc-calibrate-en|Calibrate]]** | [[loc-shunting-en|Shunting Mode]]
+  *  [[loc-index-en|Index]] | [[loc-gen-en|General]] | [[loc-int-en|Interface]] | [[:loc-speed-en|Speed]] | [[loc-details-en|Details]] | [[loc-fun-en|Functions]] | [[loc-consist-en|Multiple Units]] | [[loc-cv-en|CVs]] | [[loc-bbt-en|BBT]] | [[loc-bat-en|BAT]] | [[loc-sbt-en|SBT]] | **[[loc-calibrate-en|Calibrate]]** | [[loc-maintenance-en|Maintenance]] | [[loc-shunting-en|Shunting Mode]]
  \\
@@ Line 16: / Line 16: @@
 The max. km/h to use for calibrating.\\
 If zero the **[[:loc-speed-en#v_max_-_kmh_max_v_rmax|V_Max]]** value on the interface tab is used.\\
+====Mid. km/h====
+The **mid km/h** value used for calibration refers to the **medium speed of the decoder**, \\
+**not** to the V_Mid parameter in the *Speed* tab. \\
+When using a linear speed curve in the decoder, the mid speed should be set to **half of the maximum speed (max. km/h)**. \\
+Example: If the maximum speed defined in the decoder is 120 km/h, the mid speed should be set to 60 km/h.
 ====CV 5====
@@ Line 30: / Line 37: @@
+====Adjust====
+Correction value from 10 to 150% used during calibration to adjust the difference between CV old and CV. \\
+With some decoders, this adjustment is necessary to achieve a more accurate approximation of the correct value.
+====MV Test====
+Simulation of speed measurement.\\
+**Caution** Use only in a dummy locomotive, as the CV values are stored in the locomotive.