Table of Contents
Marklin 6050/6051
Content → Command Stations → Marklin 6050/6051
| Deprecated and no longer supported! |
Because of the lack of a direction bit in this ancient protocol some features will probably not work in auto mode.
Cable configuration
Interface 6050/6051 to RS232
| DIN-6 | D-SUB-9 | Label |
| 1 | 3 | Rx |
| 4 | 2 | Tx |
| 5 | 8 | CTS |
| 3 | 5 | Ground |
Bridge on D-SUB-9 side pin: 4 - 6 - 1
Settings
General Command Station setup dialog:
Line settings
Baudrate
2400
Hardware Flow
CTS
Sensors
Number
Number of s88 units.
Version
| Version | Command sleep | comment |
|---|---|---|
| 0 | 0ms | |
| 1 | 10ms | |
| 2 | 50ms | otherwise cts timeout |
With version 2, the direction change will skip the preceding speed zero command.
Switch time
Time in ms to wait after the last switch command before a switch off command is send to prevent coil damaged.
Use 1000 (if old and slow magnetic objects)
Interface 6023
The 6023 interface must be switched to binary mode for using this protocol; Read section 6 on how to switch to binary mode.