hello from Rein from Apeldoorn

New users can introduce themself here

hello from Rein from Apeldoorn

Postby ReinvandenBroek » 24.06.2018, 13:24

I just switched from H0 to N gauge because I moved and I donot have that much space anymore.
I used Koploper for my automation and I found rocrail on the internet.
I now am starting with it and find it very interesting.

I have a Roco multimous, Xpressnet interface and some other rosoft electronics, digikeijs switch decoder, etc.
I can connect to my electronics sofar ;-)

Greetings Rein
ReinvandenBroek
 

Re: hello from Rein from Apeldoorn

Postby smitt48 » 24.06.2018, 13:28

Hi Rein,

Welkom bij Rocrail, (oops that was in Dutch) Welcome to Rocrail :mrgreen: .

Tom
Kind regards,
Tom Smit
Kralendijk, Bonaire - Dutch Caribbean

Märklin M & K-rails with ECoS2 (4.2.3) - Win10
RoSoft: S88n & WDD switch & SDD signal decoders
Display: Tri-ang from 1950's, Märklin from early 1960's
In build phase
smitt48
 

Re: hello from Rein from Apeldoorn

Postby RedTrain » 24.06.2018, 18:05

Hello Rein

Welcome and have a successful start with Rocrail - it is usually best to work through the 'step-by-step' tutorial on the wiki. That should give you a good basic overview.

Have fun! :)
Beste Grüsse / kind regards - Carlo

[H0m 2L DCC] Layout "Rhaetian Flyer" Swiss Proto-Freelance RhB+FO+zB; 6% completed, partly operational
W10, Ubuntu 16.04, Rocweb, andRoc; CANbus GC1e, GC3-ORD3, GC2, GC6; Bemo, Peco, handlaid;
RedTrain
 

Re: hello from Rein from Apeldoorn

Postby ReinvandenBroek » 25.06.2018, 18:51

Thank for the welcome.
I am sure I will have some fun. :D
ReinvandenBroek
 


Return to Introduction