srcp, switches, and bus numbers

Moderator: Moderators

srcp, switches, and bus numbers

Postby Richard-TX » 17.04.2013, 06:59

When setting up a switch, there is a field for bus number. It appears that this field is ignored when srcp is defined as the protocol for the switch. I appears that the only place that bus number actually matters is when defining the srcp controller properties.

Is the bus number in the switch definition ignored by design?

Image
Richard-TX
 

Postby rjversluis » 17.04.2013, 07:44

The bus number is not for srcp but for other systems like selectrix, BiDiB, CBUS, ...
Best Regards, Rob.
:!: PS: Do not forget to attach the usual files.
:!: PS: Nicht vergessen die übliche Dateien an zu hängen.
[ macOS - Linux] - [ N: CBUS - CANGCx ] - [ G: CBUS - CANGCx ]
rjversluis
Site Admin
 

Postby Richard-TX » 19.04.2013, 03:47

Rob,

When I define 3 switches all with the same port and address but using different protcols, Rocrail views the switches as the same. Is there some way to differentiate based on protocol used?
Richard-TX
 

Postby rjversluis » 19.04.2013, 03:52

The selected protocol is used at "INIT GA".

http://srcpd.sourceforge.net/srcp/srcp-084.html
Best Regards, Rob.
:!: PS: Do not forget to attach the usual files.
:!: PS: Nicht vergessen die übliche Dateien an zu hängen.
[ macOS - Linux] - [ N: CBUS - CANGCx ] - [ G: CBUS - CANGCx ]
rjversluis
Site Admin
 

Postby Richard-TX » 19.04.2013, 04:14

I found a work around. Define a second srcp controller.
Richard-TX
 


Return to srcp