CLOSED - srcp and programming tab - wait for PT pop-up

Moderator: Moderators

CLOSED - srcp and programming tab - wait for PT pop-up

Postby Richard-TX » 07.05.2013, 06:38

When I am in the programming tab and select a CV and value in the "CV-Box" and press "Set" the following happens:

The message(s)
command written: SET 1 POWER OFF
srcp response: 1367904804.470 200 OK
command written: SET 2 SM 0 CV 100 66
srcp response: 1367904804.479 200 OK
appears in the Controller window:

A dialog box titled "Get CV" appears that says "Wait for PT"

Rocrail should not be waiting for anything that I can think of or is there something that the srcpd server should say?


Richard
Last edited by Richard-TX on 09.05.2013, 13:29, edited 2 times in total.
Richard-TX
 

Postby Richard-TX » 07.05.2013, 06:48

Is it possible that the request for writing a CV should be:

SET 2 SM <loconum> CV 100 66

instead of

SET 2 SM 0 CV 100 66 ??
Last edited by Richard-TX on 07.05.2013, 07:10, edited 1 time in total.
Richard-TX
 

Postby Richard-TX » 07.05.2013, 06:53

Here are the files.
You do not have the required permissions to view the files attached to this post.
Richard-TX
 

CV17 weirdness

Postby Richard-TX » 07.05.2013, 18:01

Something strange is happening with Ver. 5158

When I do a read of cv 16 all is ok. When I read CV17 then rocrail suddenly changes the loco number.

Attached is the rocrail trace. Below is an excerpt.

The loco number is 505.

command written: SET 1 POWER OFF
srcp response: 1367945820.255 200 OK
command written: GET 2 SM 505 CV 16
srcp response: 1367945820.269 100 INFO 2 SM 505 CV 16 0
addr=505 CV=CV nr=16 value=0
command written: SET 1 POWER OFF
srcp response: 1367945820.311 200 OK
command written: GET 2 SM 134567504 CV 17
srcp response: 1367945820.325 100 INFO 2 SM 134567504 CV 17 0
addr=134567504 CV=CV nr=17 value=0
You do not have the required permissions to view the files attached to this post.
Last edited by Richard-TX on 07.05.2013, 23:36, edited 1 time in total.
Richard-TX
 

Postby Richard-TX » 07.05.2013, 18:18

Sometimes when I do a get of CV17 the SM number changes to 0

Here is a excerpt. The loco number in this case is 203.


command written: GET 2 SM 203 CV 16
srcp response: 1367946971.402 100 INFO 2 SM 203 CV 16 0
addr=203 CV=CV nr=16 value=0
command written: GET 2 SM 0 CV 17
srcp response: 1367946971.437 100 INFO 2 SM 0 CV 17 0
addr=0 CV=CV nr=17 value=0

Once the SM changes to 0 it stays at zero no matter what CV # is read. If I select a different loco then the correct number is set.
Richard-TX
 


Return to srcp