SOLVED: vcurve writes only cv66

Post Reply
Richard-TX
Posts: 1372
Joined: 10.07.2012, 04:00
Location: Texas, USA
Contact:

SOLVED: vcurve writes only cv66

Post by Richard-TX » 08.05.2013, 14:26

When I do a vcurve and click OK only CV66 gets written.

A write all only writes cv1[0]

Below is a excerpt trace.

.
.
.
command written: GET 2 SM 505 CV 93
srcp response: 1368019259.938 100 INFO 2 SM 505 CV 93 0
addr=505 CV=CV nr=93 value=0
command written: SET 2 SM 505 CV 66 0 <- vcurve OK
srcp response: 1368019264.711 200 OK
command written: SET 2 SM 505 CV 0 0 <- write-all.
srcp response: 1368019549.446 200 OK
Last edited by Richard-TX on 09.05.2013, 13:27, edited 1 time in total.

Richard-TX
Posts: 1372
Joined: 10.07.2012, 04:00
Location: Texas, USA
Contact:

Post by Richard-TX » 08.05.2013, 14:55

plan and traces
Attachments
rocview.009.zip
(4.35 KiB) Downloaded 40 times
plan.xml
(15.09 KiB) Downloaded 44 times

rjversluis
Site Admin
Posts: 38689
Joined: 10.04.2006, 08:48
Location: Speyer, Germany
Contact:

Post by rjversluis » 08.05.2013, 16:03

Just give 5168 a try.

Post Reply

Return to “srcp”