Software question about LocoIO settings

Moderator: Moderators

Software question about LocoIO settings

Postby cjones7 » 20.07.2014, 08:34

Ref revision 7538, 12/7/14.
On the LocoIO window (Programming/LocoNet/LocoIO) in the setup area of the General tab there are 4 options.
If I select the option for "Alternating code for push buttons" then press set, the option for 4 position servo is also selected.

Is this intentional (say share the same configuration bit)?

Regards,
CFJ
cjones7
 

Re: Software question

Postby rjversluis » 20.07.2014, 08:57

Hi,
Is this intentional (say share the same configuration bit)?

No, it is not. Its a bug in the dialog which I have fixed in revision 7586.
Best Regards, Rob.
:!: PS: Do not forget to attach the usual files.
:!: PS: Nicht vergessen die übliche Dateien an zu hängen.
[ macOS - Linux] - [ N: CBus - CAN-GCA ] - [ 0: RocNetNode - GCA-Pi ]
rjversluis
Site Admin
 

Re: Software question about LocoIO settings

Postby cjones7 » 27.07.2014, 08:28

Ok, downloaded version 7600 which fixed the display.
Now I have another problem in LocoIO settings.
Set the addresses for each port but two different Loconet monitor programs show the addresses being applied at half the "saved" value and JMRI shows saved values as being half that of RocRail.
Examples:
Set port1 address to 80. Read back as 80. Open JMRI and read back the address as 40, loconet monitors show the associated switch_request as for address 40. Start Rocrail and read CVs and get address 80.

Use JMRI to write address for a port and then read with Rocrail get an address twice as big.
cjones7
 

Re: Software question about LocoIO settings

Postby rjversluis » 27.07.2014, 08:30

Best Regards, Rob.
:!: PS: Do not forget to attach the usual files.
:!: PS: Nicht vergessen die übliche Dateien an zu hängen.
[ macOS - Linux] - [ N: CBus - CAN-GCA ] - [ 0: RocNetNode - GCA-Pi ]
rjversluis
Site Admin
 

Re: Software question about LocoIO settings

Postby cjones7 » 27.07.2014, 10:37

Nice read but I don't see the relationship to LocoIO outputting an address half that supposedly stored in CV. :?
OPC_SW_REQ closed @ decoder address 40 != OPC_SW_REQ closed @ decoder address 80 :?:
cjones7
 

Re: Software question about LocoIO settings

Postby rjversluis » 27.07.2014, 11:12

Just decide to use Rocrail or JMRI.
4) If you are asking for support for Rocrail functionality, auto mode, switches, signals ... you have to post your rocrail.ini plan file and the trace file.
Best Regards, Rob.
:!: PS: Do not forget to attach the usual files.
:!: PS: Nicht vergessen die übliche Dateien an zu hängen.
[ macOS - Linux] - [ N: CBus - CAN-GCA ] - [ 0: RocNetNode - GCA-Pi ]
rjversluis
Site Admin
 


Return to Loconet