Limited functions after adding GenLI-USB

Moderator: Moderators

Limited functions after adding GenLI-USB

Postby fieryturbo » 18.12.2015, 06:34

So I set up my new GenLI-USB with my Roco 10761 command station, and it is terrible compared to DDX. Functions F9-F12 are repeats of F1-F4. Is this something I can reprogram in Rocrail?

Also, using DDX, I could program the locos, but without feedback. With GenLI-USB, I only get "Command not supported"

Help?
fieryturbo
 

Re: Limited functions after adding GenLI-USB

Postby rjversluis » 18.12.2015, 07:14

Hi,
5: If you are asking for support for Rocrail functionality, auto mode, switches, signals ... you have to post your rocrail.ini plan file and the trace file.


you can use this function:
http://wiki.rocrail.net/doku.php?id=issue-en
Best Regards, Rob.
:!: PS: Do not forget to attach the usual files.
:!: PS: Nicht vergessen die übliche Dateien an zu hängen.
[ macOS - Linux] - [ N: CBus - CAN-GCA ] - [ 0: RocNetNode - GCA-Pi ]
rjversluis
Site Admin
 

Re: Limited functions after adding GenLI-USB

Postby fieryturbo » 18.12.2015, 15:57

Never mind, I answered my own question.

On the page http://wiki.rocrail.net/doku.php%3Fid%3Droco-cs-en, it's clearly stated "A multimaus supports all 12 locdecoder functions, a lokmaus (2) only 8. The lokmaus gets confused when commands for 12 functions are issued. When using a locmaus it is required for each locomotive to set the number of functions on the interface tab of the loco properties to 4 (default) or 8, otherwise the lights of the locomotives will behave erratic."

Looks like I'll only be using this module for S88, and a bulb for a protection circuit. Lokmaus2 sucks compared to DDX as a command station. Too bad.
fieryturbo
 


Return to Lenz