How to update server state with other XN devices´ commands

Moderator: Moderators

How to update server state with other XN devices´ commands

Postby Lio » 18.02.2013, 20:32

I am new to RocRail and have tried several searches to answer my question myself, but I failed.

Here goes my question (XN = XpressNet):

When I run Rocrail, a change to an accessory (signal or switch) is reported among the clients, e.g. if I set signal A to stop it changes its representation in client 1 as well as in client 2. OK so far.

But when I use my controler on the XN and set back signal A to proceed, RocRail does not take notice, at least neither in client 1 nor client 2.

As there are information broadcasts on the XN it is technically possible.

So - is it really not implemented (would be a pitty) or is there a configuration which I yet missed?

Thanks a lot for answers as this is a point I heavily need.

Best regards
Frank
Lio
 

Return to Lenz