sensor state update

Moderator: Moderators

Postby jeanmichel » 06.01.2009, 14:39

Hi Daniel,

Regarding the slow refresh I should try to solve it with setting sensordebounce with a value smaller than 100 (if I correct understand)


yep this is correct! Hopefully it will work.

Regards
Jean-Michel
jeanmichel
 

Postby anam » 07.01.2009, 23:16

Hi Jeanmichel,

I did many tests using different values for sensordebounce (svn 4231).
I started from value=90 going down (five in five). With value < 10 sensor refresh rate become like svn3975. So my problem is solved.

In any case I have a question: a so low value for this parameter, may affect any other Rocrail function?


Regards
Daniel
anam
 

Postby rjversluis » 08.01.2009, 06:58

anam wrote:In any case I have a question: a so low value for this parameter, may affect any other Rocrail function?

No it won't because there was no delay before in the lenz library.
You can set this parameter to zero.
Best Regards, Rob.
:!: PS: Do not forget to attach the usual files.
:!: PS: Nicht vergessen die übliche Dateien an zu hängen.
[ macOS - Linux] - [ N: CBUS - CANGCx ] - [ G: CBUS - CANGCx ]
rjversluis
Site Admin
 

Previous

Return to Lenz