Rocrail execution error

Rocrail execution error

Postby smitt48 » 03.04.2018, 18:29

Hi Rob,

I am using the plan from Welli with his rocrail.ini, but I changed cbus and ecos to the virtual controller.
viewtopic.php?f=44&t=15763
After starting automode, a train goes to sb3 (which is full), when clicking on the enter melder the block turns blue, then clicking on the first in melder Rocrail stops running.
Version 13785 win64.

Tom
You do not have the required permissions to view the files attached to this post.
Kind regards,
Tom Smit
Kralendijk, Bonaire - Dutch Caribbean

Märklin M & K-rails with ECoS2 (4.2.3) - Win10
RoSoft: S88n & WDD switch & SDD signal decoders
Display: Tri-ang from 1950's, Märklin from early 1960's
In build phase
smitt48
 

Re: Rocrail execution error

Postby LDG » 03.04.2018, 18:57

Hi Tom,

you tested with a Rocrail version created by me. It should be identical to Robs version but please try to verfiy if the behaviour is the same when using Robs most recent version (which is newer :wink: ).

Regards,
Lothar
LDG
Site Admin
 

Re: Rocrail execution error

Postby smitt48 » 03.04.2018, 19:14

Hi Lothar,

I tested with 13791 (nightly) and no abends were found. :oops:

Tom
Kind regards,
Tom Smit
Kralendijk, Bonaire - Dutch Caribbean

Märklin M & K-rails with ECoS2 (4.2.3) - Win10
RoSoft: S88n & WDD switch & SDD signal decoders
Display: Tri-ang from 1950's, Märklin from early 1960's
In build phase
smitt48
 


Return to General