opendcc/rocrail points are powerless after read/write cvs

http://www.opendcc.de
http://www.bidib.org
Post Reply
gramels
Posts: 221
Joined: 24.12.2009, 08:32
Location: around Zürich/ Switzerland and SouthWest Germany (Südbaden)

opendcc/rocrail points are powerless after read/write cvs

Post by gramels » 25.02.2010, 22:31

This might be an other bug or just something in my config.

I recogniced that my points connected to my zweipol decoder (http://www.digital-bahn.de) did not switch, just some little motion.

After 4h of finding the bug I reapplied the default eeprom setting in openDCC.

I retested it now and recognized the following behaviour:

new flashed openDCC -> all fine, points are switching
read cv in openDCC config/ some changes/ write cv -> points are powerless
reflash openDCC eeprom -> all fine

I could not exactly identify if I set a wrong DCC setting, but the switches settings remained the same.

Any ideas?
Last edited by gramels on 26.05.2010, 03:03, edited 1 time in total.

opendcc
Posts: 137
Joined: 08.01.2009, 22:03

Re: opendecc/rocrail points are powerless after read/write c

Post by opendcc » 26.02.2010, 18:39

Hello Lothar,

I just tried this out and could see no influence. What SOs are you changing? (if i.e. You set the repetition count for accessory to 0 - you'll get this behavior.)

At this point a portmon log file could clearly identify the 'troublemaker'.

br Wolfgang

Post Reply

Return to “OpenDCC & BiDiB”