Page 1 of 1

Signals react very slow

Posted: 12.08.2016, 10:37
by Sharky64
Hi all of you,
I use an IB-basic and two-lights signals from Völkner. Rocrail and a normal signal-decoder (Rosoft, Holland).

When I use my CS by changing signals simply from RED - GREEN (or vv) a quick change of light follows.
When I use Rocrail this change takes more than 10 seconds. Where do I have to look.
Thanks for your answers,
Sharky64

Re: Signals react very slow

Posted: 12.08.2016, 10:48
by smitt48
Hi,

You can look at your setting in Rocrail properties -> automatic. Signal/semaphore commands.
Without your data it is hard to figure out.
http://wiki.rocrail.net/doku.php?id=issue-en
Tom