assaaign address to signal in rocrail?

Post Reply
rjversluis
Site Admin
Posts: 42359
Joined: 10.04.2006, 08:48
Location: Speyer, Germany
Contact:

Re: assaaign address to signal in rocrail?

Post by rjversluis » 03.03.2014, 09:40

You can include signals in the block properties to get it automatically controlled:
http://wiki.rocrail.net/doku.php?id=block-signals-en

If the signal type is just 2 or 3 aspects you can use the most simple addressing:
http://wiki.rocrail.net/doku.php?id=signals_en

Control -> default
Address -> Red/Green/Yellow

Which address to use depends on your decoder at which the signal is connected.

Post Reply

Return to “Signal Systems”