Page 1 of 1

Roco Z21 and Ulenbrock 63 320 Feedback sensors

Posted: 01.01.2019, 06:39
by RCGeek
The sensors work correctly with the Z21 on its own but there is no feedback for Rocrail. I suspect it is an addressing issue.

(I am assuming that the sensor image in my track plan should perform in a similar manner to the ones in the Demo Workspace - change from green to red and become enlarged when the loco trips the sensor.)

Cheers
Richard

Re: Roco Z21 and Ulenbrock 63 320 Feedback sensors

Posted: 01.01.2019, 07:33
by rjversluis
Hi Richard,

maybe you can find here your answer:
https://wiki.rocrail.net/doku.php?id=ro ... addressing

If not; Just use the sensor monitor:
https://wiki.rocrail.net/doku.php?id=sensormon-en

Re: Roco Z21 and Ulenbrock 63 320 Feedback sensors

Posted: 01.01.2019, 08:23
by RCGeek
Thanks rj

Thanks for your reply.

Your first link leads to a part of the Tutorial which I have read and reread - to no avail.

The second link leads to something which I feel is too complex for my issue.

I am using Bus 0, Address 17, Offset blank.

Maybe there are some Z21 users who have solved this problem who can help?

Regards
Richard

Re: Roco Z21 and Ulenbrock 63 320 Feedback sensors

Posted: 01.01.2019, 08:25
by rjversluis
Richard,
The second link leads to something which I feel is too complex for my issue.
you only have to watch the monitor... :shock:

Open this dialog, and let run a loco over one or more sensors on your layout.

Re: Roco Z21 and Ulenbrock 63 320 Feedback sensors

Posted: 01.01.2019, 13:12
by smitt48
Hi Richard,

A brand new wiki page created yesterday, please check if correct. :mrgreen:

https://wiki.rocrail.net/doku.php?id=se ... track_plan

Tom

Re: Roco Z21 and Ulenbrock 63 320 Feedback sensors

Posted: 02.01.2019, 04:39
by RCGeek
In the 1966 film "55 Days at Peking" starring Charleton Heston, the dowager Empress of China asks the question: "Who can make muddy water clear?"

I would say you certainly can Tom. Thanks.

I have to go to Sydney for a few days but I will get onto it as soon as I am back and I will post my results,

Regards
Richard

Re: Roco Z21 and Ulenbrock 63 320 Feedback sensors  [✔]

Posted: 11.01.2019, 09:06
by RCGeek
Followed the procedure in your wiki and discovered that I had the address right but the bus number wrong. Fixed that and it works perfectly. Thanks.

Richard