Page 1 of 1

[rejected] Adjustment of the working time of each sensor

Posted: 01.07.2018, 18:28
by andrey
Hello Rob.
Is it possible to make software in your product the adjustment of the processing time of each sensor, since this is implemented in feedback decoders from the manufacturers of this equipment?

Re: Realization of adjustment of the working time of each se

Posted: 02.07.2018, 07:28
by rjversluis
Hi andrey,

I do not understand your request.

Re: Realization of adjustment of the working time of each se

Posted: 02.07.2018, 10:26
by andrey
rjversluis wrote:Hi andrey,

I do not understand your request.
Fügen Sie diese Funktion in "Eigenschaften" des Sensors hinzu

Re: Realization of adjustment of the working time of each se

Posted: 02.07.2018, 10:37
by rjversluis
You mean this option:
https://wiki.rocrail.net/doku.php?id=se ... n-en#timer

Normally the sensor module is responsible for the delay to avoid too many bus traffic. To move this to Rocrail is a bad Work-Around and should be avoided.

Re: Realization of adjustment of the working time of each se

Posted: 02.07.2018, 17:56
by andrey
Rob, unfortunately most modellers use fairly simple feedback modules without any additional settings. In your software product, it would be very appropriate to have a simple interface for setting the delay time for each individual sensor.

Re: Realization of adjustment of the working time of each se

Posted: 03.07.2018, 06:37
by rjversluis
rjversluis wrote:You mean this option:
https://wiki.rocrail.net/doku.php?id=se ... n-en#timer

Re: Realization of adjustment of the working time of each se

Posted: 03.07.2018, 08:39
by andrey
rjversluis wrote:
rjversluis wrote:You mean this option:
https://wiki.rocrail.net/doku.php?id=se ... n-en#timer
Rob, maybe we do not understand each other. The reference you gave is the "Off" timer of the sensor. I also mean the "Turn-on" timer of the sensor. Or I do not understand anything at all :-)

Re: Realization of adjustment of the working time of each se

Posted: 03.07.2018, 09:49
by rjversluis
andrey wrote: The reference you gave is the "Off" timer of the sensor. I also mean the "Turn-on" timer of the sensor.
There will be no "Turn-on" timer in Rocrail.
As soon as a sensor is on it should be processed immediately.