[solved] Incomplete translations in the Schedule dialog

[solved] Incomplete translations in the Schedule dialog

Postby RainerK » 07.05.2018, 14:57

Hi Rob,

the last changes in the dialog schedule "destinations" the existing translations are incomplete realised.

For example in the DE dialog (rev 13.952):
In the Table column header is "depart" not translated but at the Input fields is "Abfahrt" correct shown.
In the Table column header is "Abfahrt" correct shown but at the Input fields is "Arrive" not translated.

Please look at the Colour markings in the picture below.
schedule-translation-errors.png
You do not have the required permissions to view the files attached to this post.
Last edited by RainerK on 08.05.2018, 10:49, edited 1 time in total.
Best Regards, es grüßt RainerK

DCC++ with Arduino Uno / Motor shield and LocoNet GCA85, 50, 93 and 136. Special interests: DIY electronic assemblies. http://www.rainermoba.blogspot.com
Planning replace the coincidence by the mistake
RainerK
 

Re: Incomplete translations in the Schedule dialog

Postby rjversluis » 07.05.2018, 15:07

Hallo Rainer,

ich habe es korrigiert:
scheduledialog-de.png
You do not have the required permissions to view the files attached to this post.
Best Regards, Rob.
:!: PS: Do not forget to attach the usual files.
:!: PS: Nicht vergessen die übliche Dateien an zu hängen.
[ macOS - Linux] - [ N: CBus - CAN-GCA ] - [ 0: RocNetNode - GCA-Pi ]
rjversluis
Site Admin
 

Re: Incomplete translations in the Schedule dialog

Postby RainerK » 08.05.2018, 10:49

Hi Rob,

in Rev. 13.954 it's ok.

Thank You.

:rr_for_ever:
Best Regards, es grüßt RainerK

DCC++ with Arduino Uno / Motor shield and LocoNet GCA85, 50, 93 and 136. Special interests: DIY electronic assemblies. http://www.rainermoba.blogspot.com
Planning replace the coincidence by the mistake
RainerK
 


Return to Translations

cron