Help for my command station

All issues about RailCom
Post Reply
Buddace
Posts: 881
Joined: 04.09.2008, 15:54
Contact:

Help for my command station

Post by Buddace » 09.02.2011, 01:38

I would like implement railcom support in my command station..i have question because NMRA RP are not clear for me..
To enable based decoder transmission is enough cut first two dcc preamble bit?
Read "cut" like set both rail in "off" conditions, 0V.

opendcc
Posts: 137
Joined: 08.01.2009, 22:03

Re: Help for my command station

Post by opendcc » 12.02.2011, 20:04

Hi, cutout means 'short' at command station side, either both outputs to '0' or to '1'. On my webpage you'll find a diagram with the timing.

br Wolfgang
http://www.bidib.org
http://www.opendcc.de

Post Reply

Return to “RailCom”