First alpha support for the MERG CBUS.

First alpha support for the MERG CBUS.

Postby rjversluis » 24.06.2011, 18:36


the MERG CBUS is an open source project based on the well known industrial CAN-Bus.
Many MERG members are involved in creating hardware and firmware for this open standard which also was one of the reasons to add support for CBUS in Rocrail.

I coded the last two weeks over 2000 lines including a setup dialog.

From Mike I will become a CBUS test setup including a CBUS Command Station.

Peter, well known from the MGV hardware, is also designing for this system and will integrate this in the same cable as the one used between the MGV50 modules. CAN is part of Peters professional live.

I hope to get started with testing after holidays.
In the mean time you can get your self informed by the link section on the CBUS page.
Best Regards, Rob.
:!: PS: Do not forget to attach the usual files.
:!: PS: Nicht vergessen die übliche Dateien an zu hängen.
[ macOS - Linux] - [ N: CBus - CAN-GCA ] - [ 0: RocNetNode - GCA-Pi ]
Site Admin

Return to mergCBUS