Turntable rotating 180Deg twice

http://www.merg.org.uk/merg_resources/cbus.php
Post Reply
MikeBr
Posts: 18
Joined: 08.07.2016, 18:33

Turntable rotating 180Deg twice

Post by MikeBr » 25.11.2016, 22:16

Hi,
I have created this simple layout to test a Merg CBus project to control a turntable using a stepping motor. The goto track commands work as I expected and the turn through 180 deg also controls the motor as expected but the visua
turntable.zip
Simple turntable layout
(4.69 KiB) Downloaded 2 times
l image of the turntable on the screen does not finish in the correct position.This happen on the second command to switch through 180 deg.
The image on the screen after the second switch leaves the turntable at 2 O'clock or there abouts.
The stepping motor is in the correct position after the second switch through 180 deg but the image on the screen is not correct. Is ther some setup I have missed?

Regards
MikeBr

Post Reply

Return to “mergCBUS”