(operator error) PM Messages not showing up

(operator error) PM Messages not showing up

Postby smitt48 » 07.07.2018, 14:25

Hi,

I tried to sent a Personal Message, but they are not showing up in the outbox or in "sent messages".
Replies seem to work OK.
I thought it had something todo with upper/lower case in the name, but it does not work with the name selected from the index.
Does this have anything to do with http(s)?

Thanks Tom
Last edited by smitt48 on 07.07.2018, 16:26, edited 1 time in total.
Kind regards,
Tom Smit
Kralendijk, Bonaire - Dutch Caribbean

Märklin M & K-rails with ECoS2 (4.2.4) - Win10
RoSoft: S88n & WDD switch & SDD signal decoders
Display: Tri-ang from 1950's, Märklin from early 1960's
In build phase
smitt48
 

Re: PM Messages not showing up

Postby rjversluis » 07.07.2018, 14:28

Hi Tom,

did you get my PM?
It did show up in the outbox.
Best Regards, Rob.
:!: PS: Do not forget to attach the usual files.
:!: PS: Nicht vergessen die übliche Dateien an zu hängen.
[ macOS - Linux] - [ N: CBus - CAN-GCA ] - [ 0: RocNetNode - GCA-Pi ]
rjversluis
Site Admin
 

Re: PM Messages not showing up

Postby smitt48 » 07.07.2018, 14:31

Hi Rob,

I got it.
You have more rights than I do!

Tom
Kind regards,
Tom Smit
Kralendijk, Bonaire - Dutch Caribbean

Märklin M & K-rails with ECoS2 (4.2.4) - Win10
RoSoft: S88n & WDD switch & SDD signal decoders
Display: Tri-ang from 1950's, Märklin from early 1960's
In build phase
smitt48
 

Re: PM Messages not showing up

Postby smitt48 » 07.07.2018, 14:46

Hi Rob,

Probably operator error. :oops:
I think I forgot the subject line, did not notice there was probably an error message.
Time for football!
Tom
Kind regards,
Tom Smit
Kralendijk, Bonaire - Dutch Caribbean

Märklin M & K-rails with ECoS2 (4.2.4) - Win10
RoSoft: S88n & WDD switch & SDD signal decoders
Display: Tri-ang from 1950's, Märklin from early 1960's
In build phase
smitt48
 


Return to General